Here are a few hints for network installation if things dont work as expected. Then performed doing a special manual action right on the device. ThisĬontroller is turned into exclusion respective inclusion mode. This process is called Exclusion.īoth processes are initiated by the primary controller of the Z-Wave network. To be added to an existing wireless network to communicate with the devices of this network.ĭevices can also be removed from a network. On factory default the device does not belong to any Z-Wave network. Every Z-WaveĬontroller is able to perform this operation however it is recommended to use the primaryĬontroller of the previous network to make sure the very device is excluded properly Performing an Exclusion operation as described below in the manual. Please make sure to reset the device into factory default. In order to include (add) a Z-Wave device to a network it must be in factory default Please read the user manual before installing the product. The Ring Alarm Base Station is required to enable Keypad features and functions within the Ring app. After installing the Keypad and setting up the Keypad in the Ring app, perform arming and disarming actions as well as receive system indications for different status updates and events. Ring Alarm Keypad is a wireless accessory for the Ring Alarm system which provides users the ability to arm and disarm their system, view system status, and manage alarm conditions. Otherwise it will automatically turn into a lower level of security to maintainįor more information about Z-Wave technology, devices, white papers etc. Secure as long as this device provides the same or a higher level of security. If a device supports secure communication it will communicate with other devices This device and every other certified Z-Wave device can be used together with any otherĬertified Z-Wave device regardless of brand and origin as long as both are suited for the ( meshed network) in case the receiver is not in direct wireless range of the Z-Wave ensures a reliable communication by reconfirming every message ( two-wayĬommunication) and every mains powered node can act as a repeater for other nodes Thisĭevice is suited for use in the region mentioned in the Quickstart section. Z-Wave is the international wireless protocol for communication in the Smart Home. Follow the disposal instructions.ĭo not dispose of electronic equipment or batteries in a fire or near open heat sources. Use this equipment only for its intended purpose. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Failure to follow the recommendations in this manual may be dangerous or may violate the law. I can’t see how this would be related to my konnected alarm panel as even choosing find sensor and having it play a sound to locate the keypad doesn’t work.Please read this manual carefully. Tried changing the sound and that made no difference. I can see in the IDE that the trigger for the chime is sent, but I get no sound. Similarly arm/disarm all work fine as does siren and strobe, it’s only the chime that doesn’t work. In the IDE I can see that it is S2 connected. Also distance from the hub can’t be the issue as it is sat with a couple of feet. I also don’t believe that it is a buffering issue as it would be intermittent, this appears to be the only functionality that doesn’t work. There is no mesh for packets to get lost in as I have no other devices connected to the hub. Only difference is I have the Aeotec hub (which appears to be a rebrand of the Samsung v3). I’ve got exactly the same issue, even to the point where I was told it could be a local issue with the keypad, so i ordered a new one and have the same issue with that so it’s not hardware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |